Automative SMT Electronics PCBA Board

Automative SMT Electronics PCBA Board

Quick Details Place of Origin: Guangdong, China (Mainland) Brand Name: OEM Model Number: MK-PCBA-0906J01B Base Material: FR4 Copper Thickness: 1oz Board Thickness: 1.6mm Min. Hole Size: 0.25mm Min. Line Width: 0.075mm(3mil) Min. Line Spacing: 0.075mm(3mil) Surface Finishing: HASL Max Panel size:...

Chat Now

Product Details

Product description:

When we made the board, there were several ways to connect the wires to this Automative SMT Electronics PCBA Board. You can connect the wires directly to the metal plating on the surface. We can also use a powerful drill hole, or drill a drill bit with a metal plate and tighten the wire through the bottom weld just like a standard weld. We can also replace the solder joints with our own wires. Heat the wire end protruding from the solder joint while pulling out the wire. Make sure to re-create the hole by pushing the tip of the iron into the hole or using a desoldering tool, or pass the new wire through the heating point. Add some new solder or flux to remove oxidation. Do not pull the welded joints with this Automative SMT Electronics PCBA Board. Automative SMT Electronics PCBA Board's metal plating is easily peeled off from the PCB. Sometimes a utility knife can be used to cut off the solder in the wrong position. If the attachment does not appear to be fixed (usually because the rubbery material is in the process of melting), scrape the metal surface again.

Product specifications:

Place of Origin: Guangdong, China (Mainland)

Brand Name: OEM

Model Number: MK-PCBA-0906J01B

Base Material: FR4

Copper Thickness: 1oz

Board Thickness: 1.6mm

Min. Hole Size: 0.25mm

Min. Line Width: 0.075mm(3mil)

Min. Line Spacing: 0.075mm(3mil)

Surface Finishing: HASL

Max Panel size: 800*508mm

Board finished thickness: 0.2-4.0mm

Tolerance of finished panel thickness: ±10%

Surface Treating Process of Inner layer: Brown Oxide

Layer Count: 1-18

Impedance control and tolerance: 50O±10%

Peel strength of line: =107g/mm

Wrap and twist: =0.5%

Standard: IPC-A-610D

Service type: One-stop turnkey service

Previous:FR4 Printed Circuit Card Assembly Next:Electronic Prototype PCB Assembly

Inquiry